I mail ordered a bubbler.

BUT it has this sorta threaded connector on the top:
START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE

Apparently for this type of regulator:
START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE

My regulator features more of a "nib" O2 output connector though:
START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE

What to do? Is there an adapter or something I can get to reconcile my bubbler with my regulator? If so, much likelihood of getting one at a local type medical/oxygen supply place?

If it were me I'd drop a length of hose to just off the bottom of the bubbler and then use a tube of silicon sealant to make it air tight at the top.

Hopefully someone will be along with a "proper" solution for you.

Good luck...

-Dennis-

bejeeber wrote on Sep 3^rd, 2009 at 1:55pm:

I mail ordered a bubbler. BUT it has this sorta threaded connector on the top: START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE Apparently for this type of regulator: START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE My regulator features more of a "nib" O2 output connector though: START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE What to do? Is there an adapter or something I can get to reconcile my bubbler with my regulator? If so, much likelihood of getting one at a local type medical/oxygen supply place?

I'd suggest if what you are saying there is a threaded connector at the top it  is a compression fitting in that if you undo the threaded section you will find that you can push a length of o2 hose through & into the bubbler or it will make a connection with a hose that is already there, when you tighten the threaded fitting it should clamp down onto the o2 hose creating a leak proof joint.
Can you take a photo of the threaded connection when it is disassembled it will help identify how it works.

Cheers
Barry

Thanks Barry but that threaded section doesn't undo - it really looks like its made to fasten to the type of male connector seen on this type of regulator (towards bottom of photo):
START PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGESTART PRINTPAGEMultimedia File Viewing and Clickable Links are available for Registered Members only!!  You need to or END PRINTPAGE

(Hopefully these images are showing up for ya)

Looks like you may have to take both to a gas supplier & have them match up some fittings for you.
Good Luck
Cheers
Barry